Search results for query: *

Thanks for the info. I will buy some different powder and save the 300mp for my hollow points. I did some searching and seems like 2400 is a favorite for 357. I will start looking.

I just bought some bulk Berry's bullets for 357 mag, 158 grain plated. I'm using starline brass and CCI 500 small pistol primers. I have some Alliant powerpro 300MP powder I'd like to use. Alliant has some data on their site. I believe it is 18.6 grains for 158 hollow points reaching a...

I have the M1a Scout. Never had a single malfunction. It is heavier than my AR but an awesome rifle. I love it. Everyone should own at least one. Buy quality mags, you will be happier.

Have had no problems with mine. Only put roughly 3-400 rounds through it but no malfunctions.

At the time this all happened I was using Federal gold match 168 grain with new Springfield mags. The gun would fire, cycle, but not strip a new round into the chamber. The magazine was seated properly. I checked multiple times. It was very obvious where the operating rod was striking the...

Ok, I am getting really really frustrated with the quality of new guns. I have sent two "performance center" Smith and Wesson revolvers back for problems (both fixed now). I purchased a new Springfield scout squad to update from my SKS. Less than 75 rounds and the operating rod is striking...

I have been reading off the forum for a long time here but never posted before and decided I had to speak up on this one. I have had two brand new Smith performance center revolvers, 627 pro and a 629. They were both junk. The 627 had to be sent back for light striking (I tried multiple types...