I'm getting ready to install my benchtop for my reloading bench and I am wondering where to place the Ultramount. What is the preferred placement of the press, close to the edge or do you push it back away from you.
I'd like to only put one set of holes in the benchtop. :)
Anybody have disassembly/reassembly instructions for one of these. I have one that could use a good cleaning as well as parts replacement and would like to have a guide before I just start tearing things apart. In my experience the reassembly is what gives me the most trouble:banghead:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.