Search results for query: *

I'm with the previous posters in that I do not correct others unless it is a potential safety issue, or if they ask for clarification on a particular term or issue. My inlaws use 'clip' when they are really talking about a magazine... I use the correct term when discussing guns/magazines...

Do you use the coarse or fine HF walnut? Thanks

I was wondering if the Hornady lnl classic single stage press would make a good companion for my LNL AP? I’m thinking a single stage for those miscellaneous tasks where a single stage press may be more appropriate than a progressive press – working up low quantity loads, decaping, sizing rifle...

Yep, had a great time again this year, looking forward to next year.

Good point. Sometimes it feels like we spend more time worrying about how we look and running each other down than we do standing together and fighting for the 2A.

Very well stated and right on the money.

Missed last year, looking forward to this year.

Bob, Thanks for the update, sometimes things just don't work out. And thanks for facilitating this deal every year, it certainly is one of the highlights of my year. Lots of shooting, good food, and most importantly, great people. Wayne

Excellent description, makes a lot of sense. Thanks

In my opinion, yes, the quality has gone Way downhill. My wife was kind enough to buy me a new manufactured 39a as a gift a year or two ago. As you all know this is an expensive rifle at $550. She bought the rifle from one of the local gun shops. While I obviously greatly appreciate such a...

Thanks for the replies. I think I'll try the RCBS dies to change it up a little from the Hornady's. This set? http://www.natchezss.com/product.cfm?contentID=productDetail&prodID=RC20415

What dies should I get to reload .380 in an LNL? I use Hornady die sets for .45, .38/.357, 9mm, .223 but was wondering if there is a particular die set that is more suitable for the .380? Also, can folks recommend a bullet to use? I'm on the road right now and won't be near my reloading books...

Stumbled across this poster at Blockbuster earlier this year, $20 or so.

Nematocyst, Did you ever get your 39 straightened out? I seem to recall you had a smith do some work on it and you were going to have the barrel cut down? Did the smiths work help your situation at all and if so how long did it take for them to do the work. Thanks And thanks for your...

Thanks for the replies, it sounds like there are several options I can look into. I am a bit concerned about the current tops ability to take any sort of adhesive due to the many years of oil/grease/solvent soaking it has absorbed. I do have a sheet of 1/2 osb I could screw down on the...

I have a very heavy duty bench in my shop that I am going to use for the reloading bench. This bench is made out of large timbers and is extremely heavy and stable. It currently has a plywood top over the timbers and has been used for mechanic work up until now, and it is pretty chewed up. I...

I recently received an LCP and am in the process of gathering the dies and bullets needed to reload this caliber (have the powder and primers on hand). In the mean time I wanted to purchase some factory ammo so I could shoot the gun and use the brass for future reloading. I purchased 5...

Thanks for the replies, I shall set off in search of some dies.

Thanks for the replies. On the Lee dies, do they work ok in the LNL? I ask because I seem to recall when I was researching the LNL a couple years ago there was something about the LEE dies maybe not having enough die body length for proper adjustment in the LNL? (This press has the retrofitted...

Recently received an LCP and need to get a die set for this caliber that will work well on the LNL AP press. All of my current die sets are Hornady. The Hornady dies have worked ok I suppose, although I think the fit and finish is below that of the old Pacific die sets I've used in a...