Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.
There may be some to a die hard fan of the O/U, but quick second shots, reduced felt recoil & being pretty commonly available for +/- $400 is not a drawback, IMO. I found a pretty(really) nice one at a LGS a few years ago for $425.
Even if you don't like it and desire something else, you should...
The 1100 that i bought had a 28" ribbed fixed choke barrel. I just put a 30" ribbed choke tube Remington barrel on it. So far I like it and can change chokes, if i desire. I use it for Trap an enjoy the 1100....good luck in your search.
Normally, Heat will aid in breaking a Loctite bond. Maybe use a soldering gun/iron to direct the heat to the heads of the screws. Then re-try to remove the stuck screw.
I'll throw in a vote for a used Remington 1100 semi. I do pretty good with mine against all the singles & O/U's at my club. I certainly have fun and I'm out there without a huge investment.
I went in to Cabela's looking to buy a RCBS hand trimmer and the associate working turned me on to this Lee setup. I tried it this weekend with a 1/4" drive battery operated screw driver and it worked great! Plus it was a lot cheaper than the RCBS trimmer. Until the new Lee trimmer comes out, I...
Pistol rotor and metering assembly was cleaned and installed this afternoon. RCBS powder check die will get setup tomorrow. Thank You all for the help.
I am finally getting around to setting up my LNL AP and I have a question. With the case activated powder measure Hornady included an extra rotor and metering assembly with no real explanation of when to use it. Other than on the parts list it says Small Pistol. Should I use that assembly with...
I've had a similar experience with my Chargemaster. I wipe the pan and platen with a used dryer sheet. I also turn my unit on a half hour or so prior to using. I calibrate and weigh my charges with the breeze cover in place. If you have a manual scale, double check the load to see if it verifies...
Take this info for what it's worth. I have a full size M&P.40. I've shot the 9mm and wasn't overly impressed, don't know why. I've shot the .45 and liked it, but decided on the .40 figuring the ammo would be cheaper, and it is. I just took up reloading and I shoot 180 grain FMJ at low/starter...
I currently have a RCBS single stage press with RCBS electronic powder dispenser/scale. It all works great and accurate, but a little slow. I'd like to be able to increase my output, without sacrificing quality of the reload. The last rainy weekend I spent too many hours to complete roughly 350...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.