Search results for query: *

:neener: I have a Whammo Powermaster Crossbow rifle type. It is complete, but missing a complete spring paw release spring. If you have one of these in working order I would appreciate a picture of the spring in the spring release paw. I can make one but unsure of one end and where it...

So, a tale I have to tell and I thought at the time it was funny. On Saturday I went shooting with Son In Law and Graddaughter whidh was fun. I took my Glock 36 that I had replaced a slide release lever in and a 22 Ruger MkIII. We had a good time and both guns perm\rored almost flwlessly...

I purchased a Glock 36 several years ago. It fired fine for a while then started not feeding. I changed bullet style which seemed to take care of that problem. This past weekend went to our indoor range and it would lock open on each shot. checked out the slide stop lever which as staying up...

OK so I purchase a bunch of Lee Factory crimp dies. The pistol dies work well for my main calibers. I also have two rifle factory crimp dies, one in 223 Rem the other in 308 Win/30-06. Here in lies my problem/question. I prefer using a Vickorman seating die for both 30 calibers using...

:neener:I need some help here!!! I just purchased a perfect Ruger blued Old Model Army Revolver, 71/2' barrel in excellent condition. I have been looking at the Kirst Konverter in 45 ACP. They are quite expensive and I would appreciate some imput from someone in this wonderful group who...

I recently aquired a Glock 36 which has three clips all with the magazine extension and it shoots great. It also has the trigger button safety which I like. Like the Springfield XD in 45ACP it doesn't feed SWC bullets. The slide release clip tang sticks out and the mazazine follower indent...

For those that have some of this powder from China, it is a good powder, very useful for the 223 Rem, etc. Attached below is the date sheet I received with a shipment of the powder probably ten years ago. http://yfrog.com/ebcopyofnewpicture3p...

Are tapered crimp dies a good thing to use? Also, just how are they adjusted to work? Do all the cases have to be the same length? What brands work the best? Thanks for you imput

I have the following stuff: 1 Lyman Spart T press w/o a ram, good for parts, like new 1 RCBS green single state press complete, good condition 1 Herters No. 3 press with lots of dies, shell holders including a universal for RCBS style shell holders. all new never used Adapter for RCBS...