Search results for query: *

Try JB board polish. It can be purchased through Brownells. Non imbedding.

Just that easy

Pin is not tapered or staked in.Just drift it out.

CZ Recrown....looking at the second picture the bbl looks like it has a lot of fouling..maybe copper...clean bbl as well

trigger reset Give it a complee cleaning and lube.It just could be crud built up.

If internal springs are rusted they will be weakened. Best to remove ,inspect and replace if necessary all internals before putting it in Evaporust.

break top I think it should work fine. You are shooting 22 rimfire....give it the" pull string test" to be sure and have fun.

Send me one and I'll match it up and send you five back. P/M me with your address info etc. John

If you are located in SoCal I can help. PM me.

I have a set price for repairing a firearm......Double that if he has fixed it before.

http://redmansrifling.com/ They do a great job.

Broken firing pin.

Should not be a problem.

The mag cut off will not allow the carrier to operate unless it is pushed in all the time. Please PM me if you have any knowledge of this model.

Drift out right to left.

It's a 14 1/2 with a tubular strut that intersects with the rolling block strut. I looked at the drawing you referenced and its close but not quite there. Trying to save cust some $$$$ by finding one rather than make it.

As the title says. Any ideas?

What do you need done?

2ndGen Colts are always going up in price no matter the condition. I would leave it alone and get the 44 you want.

Not a bad job.Looks good.