Search results for query: *

Got a Smith and Wesson 64-7 at a local gun show recently. It's got the side lock, and the MIM parts that people seem to talk about a lot on the forums I've come across while searching for info about it. It's a stainless 4" model in good condition, but needed a new set of grips. 2003-ish or so...

Loaded up some 69gr SMKs for use with an 20" 1:9 AR15. Powder was H335 with CCI small rifle primers (not magnum primers). Brass was Remington, with 2 firings though it previously. At 25 grains, 2 out of 10 rounds popped the primer out. At Lyman's 49th book-listed max of 25.5 grains...

I've got a Winchester Model 1300 XTR that is in need of a new finish. The original finish was a high-polish gloss blued finish, that has seen its share of scratches and dings over the years. The thought is to blast it and parkerize it, but with the receiver being an aluminum alloy, my...

Picked up a box of 165gr Nosler Spitzer bullets to run through my FAL and had some disappointing results using 44.0gr Varget with WCC Nato brass and WLR primers. Tightest group was around 3", with the widest being 4"+. Considering this rifle has produced <1" repeatable groups in the past, I...