Search results for query: *

Does anyone know if FN is going to release the Scar SSR for civilian sales. I want to get one. I am hoping there are some dealers out there that might have some idea. I am willing to get on a waiting list if it is possible. Chris

I checked this out with my local gun store today. You are correct. There is no need for a C and R license. You will still have to apply for the individual license for each silencer get finger printed and have the sherrifs department sign off on the permit. But it is much easier than before...

I have 2 ar rifles and for the cheapest round go to high tech ammo and get full metal jacket bullets. Sometimes he is out and only has machine pulls but they work just fine. Some of them are armor piercing ie, steel core so you can't shoot them at an indoor range. One of my rifles is setup...

Mal H could you please revise my username I would appreciate it. I keep trying to log on using the correct spelling and keep getting the message that my username and password don't match.

The rifle/pistol is an encore. Sorry for the spelling I wasn't using spell check and I was writing this late at night. The powder again another typo was WC846. That being said. The range report for today. I have concluded that the velocity was too low. I used a chronograph and checked...

Its pricy but I just bought one from Nightforce. Check Larue tactical the only problem is they are quick release and I am skeptical of how good they are even though I have one on my 50 BMG. For your AR 10 it should be fine. Keep in mind I have nver seen a cheap one piece mount. You are...

I think you will find that getting risers for the scope so you can use the open sight sounds like a good idea but IMHO it doesn't really work that well. I set this up on an sks once and realized that the rings and scope made it very hard to use the open sites because you can't see the target...

The bullets are definetly key holed. I am puting the targets on a piece of fiber board and you can take a bullet and it matches exactly. It is even tearing through the fiber board side ways. When the bullets don't keyhole they are very tight groups at 100 yds less than 1/2". Surprisingly...

I cannot remove the muzzle break as it is welded onto the barrel. I have an old barrel without a muzzle break. That I am also going to try tomorrow. It isn't in as good of condition but I want to see if they do the same thing. I suspect that the bullet isn't traveling fast enough.

Exactly like to see the red mist. We do use spotters but its not the same.

Thank you everyone for replying. There is a correction. I am using WC 840 powder at 31 gr. I have cleaned the gun very well before I had this problem and there is nothing that I can see wrong with the barrel except some build up between where the barrel stops and the muzzle break starts that...

I have a thompson contendor encore rifle chambered in 22-250. I have a custom muzzle break on the barrel. I was at the range last weekend getting ready for my annual prairie dog trip and started to get keyholes at 100 yds. I have been trying to figure out what is causing this. I am using a...