Search results for query: *

I just spent the entire afternoon chasing a dream. APD (Albuquerque Police Dept) used to have a unit that dealt with the ATF Form 1's and 4's, but I found out sometime in the last 2 years they shut the unit down. I was then sent to NM State Police, whom refused to review or sign my Form 1's. I...

I'm currently using a YHM Cobra M2 .45 can on a G21 and G19. I've been handloading for a few years now, and finally got my hands on some Titegroup. Everything I've read on Titegroup indicates this powder is a good choice for handloading for a suppressed pistol as it is faster-burning. I used the...

I've been reloading pistol for almost 2 years now, but will start working up some rifle loads soon. I have a bunch of Hornady #3037's to play with along with some Lake City once-fired surplus brass. I know to knock 1-2 grains off of loads using military brass (per my Lyman's #49). Just wondering...

I'm trying to trim some weight on my Varmint a4 20" AR15, and I want to replace the free-float handguard with something a bit lighter and more accessory-friendly. The upper uses a heavy-profile barrel (.920 at the gas block, 1.075 under the handguard). What are your suggestions? What are you...

I've been on the forum for a few years now, but this is my first time posting in the H&R section. I've been slowly putting together a reloading setup with a single-stage press. I am very close to starting; my plan is to reload for 9mm, 45ACP, .223 and .308. I need a load data book that...

I have a Kabar #2211 (Big Brother) and I am looking for a MOLLE sheath to mount it to my rig. The blade is just under 9.5" long and just under 2" wide. I have looked high and low and cannot find anything. Ideas?

I recently bought a Zastava PAP M92 in 7.62x39 and want to install an underfolder or side-folder on it eventually. I've already installed a krink brake and detent kit. KVAR has Bulgarian underfolder kits for $100. I know I would need to find an underfolder trunnion if I went that direction...

My next NFA project will be to add a suppressor to my collection, and I would like something user-serviceable. My first intention was to get a 5.56 can, but a 7.62 can would be nice, too. I don't need anything in titanium, so carbon/stainless steel would be preferred. Any ideas?

I'm starting a 37mm DD project, and will be using a Spikes Tactical STZ 12" launcher. I plan on getting a stand-alone stock setup sometime down the road. I already have an SBR, and have experience filling out Form 1's. My big question is the engraving. From what I gather from the ATF website...

I finally sold my old AR and received my brand new RRA complete lower tonight. I would like to know if anyone in the Albuquerque, NM area knows of any reputable engravers so I can make an SBR. I know there are reputable places to ship to out-of-state, but I want the quickest turnaround time and...