I'm trying to line up everything I need to load for my Bushmaster and think I'll go with the RCBS "X" sizing die. I plan on using this on my Hornady L-N-L AP progressive as opposed to my single stage.
Any comments.
Cloudpeak
I have very occasional stovepipes in my CZ Compact (9mm).
My go-to troubleshooting guy (1911Tuner) on the M1911.org forum stated (in regard to 1911's):
I am shooting reduced loads (Lee 105 gr SWC with 3.5 grains of W231) and I did install a 16 # recoil spring (17# is factory) as the brass...
Well, in all of the cast bullet loads I worked up for my XD40 cal., I never had a FTF. I found a load that was very accurate and loaded 450+ rounds and have now found that they don't feed worth a hoot. They're too short and hang up on the feed ramp. So, can I buy an inertia puller, put some...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.