Search results for query: *

RM, 22.5 grains of H335 under the Hornady 75 gr HPBT match is my go-to load for accuracy in my 24 inch barrel AR target rifle. I've owned a number of bolt action and AR rifles in this caliber and H335 has been the best in every one of them. I'm getting 2724 fps out of my 24 so, it's...

I am a nursing student full time and work at a hospice organization part time. I can tell you that humans can sometimes show what I call residual neuronal activity after death. At my organization, after a patient passes, I am responsible for providing post-mortem cares which consist of...

Yeah, I was surprised by the data on that XM 193 also. I've never had very good accuracy out of any gun I've owned using that federal stuff but not only did it have good numbers in this new gun but it shot pretty accurately too.

About 30 rounds each.

Ok, so I finally got out to do some shooting and data collecting on my new AR-15 varmint rifle. Rifle is a Wilde chambered 24 inch Wilson stainless bull barrel. My question is: given this caliber and this barrel, what is considered good, average and poor Standard deviation and extreme...

re: RSrocket's reply; I seat and crimp in separate steps. My seating die is adjusted far enough UP that it doesn't "crimp" at all during the seating process. It's the shaving of the plating that I avoid by doing the two distinct steps.

Am reloading my first batch of 9mm and have a question on removing the bell from the mouth of the case. I only put the absolute minimum bell on each case...just enough to get the bullet started. All my cartridges fit my chamber just fine without crimp. Is it required to taper crimp the...

I have the 16 inch Stainless PSA upper with the 1:8 twist. It shoots the lighter bullets better than the heavier ones. I've had pretty good luck with the 40 gr V-max.