Search results for query: *

  1. B

    Clean burning 44 mag powder recommendations?

    Thanks for the feedback. I purchased some reloads and the powder was so inefficient burning that it was gumming up the cylender rotation after about 50 rounds. I have reloaded for over 5 years and this was my first experance with this issue. I have some 2400 on hand so I will try it and may a...
  2. B

    Clean burning 44 mag powder recommendations?

    My Smith mod 69 44 mag needs a clean burning powder any recommendations? I need recommendations for 44 mag and 44 special loads.
  3. B

    Judge upholds Seattle 'gun violence tax' despite challenge from gun rights groups

    He's not right but if he was right wouldn't he need to tax the automobiles also? The simple facts are that no one will buy there ammo or there guns in the city so there really will not be any applicable increase in tax revenue. Just another liberal playing to the voters.
  4. B

    Tension between hunting ethics?

    Huntsman above is right. Do what has to be done depending on your own reason for hunting. It is a morals question and every one knows that every person on the planet has different morals and we all think we are right. It's your call if it is legal.
  5. B

    Can you hit the broad side of the barn with a Ruger LCR?

    The issues will be with the shooter and not gun itself. I had issues when I got mine and after a lot of practice can hit 6 inch targets when I am on the move at 30 feet. All guns will shoot different ammo to a different POA. Mine is a 357 and it likes the 38 special +P or 357 ammo much better...
  6. B

    Rossi model 92

    It is just the front sight that I am having the problem with so far. I may try the white paint idea. What type or brand of enamel paint should I use on the steel so that it will stick and not rub off?
  7. B

    cost to reload 12 gauge?

    I reload everything except shotshells for the following reasons. Dove and target loads are 25 cents a round including the tax at Walmart during season and they have never been out of stock. My calculated cost is around 22 cents per round. For the differance of 3 cents per round I can shoot...
  8. B

    Rossi model 92

    My Rossi 357 lever gun needs some type of hi viz sights. I just cannot pick up the front sight on a consistent basis in low light. It shoots dead on the money at 100 yards with the factory sights, when I can see them in the middle of the day. The problem is obviously with my older eyes. The...
  9. B

    Adjustable scope bases

    RC would the type of rings you speak of fit on the Weaver bases?
  10. B

    Adjustable scope bases

    I am in need of some adjustable scope bases as the new scope the wife got me will not align with the bore of the rifle. Windage is the issue. Not wanting to spend a lot on these bases as the gun and scope together we're less than $500-savage 223 caliber. Do you guys have any recommendations?
  11. B

    44 mag for SD Question

    I want to thank everyone of you for your time and opinions based on research and experience. I believe I have decided to stick with my 357 Hornady loads for my CCW and go with the Barns 240 grain Vortex for my 44 mag as a woods load. You guys have a wealth of knowledge thx for sharing.
  12. B

    44 mag for SD Question

    It seems we are getting to a lot of lap over bullet weights and FPS between the 357 and the 44 mag/special. So given the fact that I have both the 357 mag and the 44 mag, what would you guys think is the best bullet and weight and fps for a self defense round from either caliber? My current...
  13. B

    44 mag for SD Question

    Team I guess where I am going with this question is this, what is the advantage of the slow moving 44 mag or the 44 special over the 357? Or is there an advantage? I know the 357 is much smaller and easier to carry in almost any make or model gun. Just trying to fill in blanks in my mind...
  14. B

    44 mag for SD Question

    it is obvious to most people that most full house 44 mag loads are just way too much for SD because of the over penetration issues. My question is as follows: You have the ability to shoot slow moving (800-900fps)44 mags along with a 300 grain weight bullet for SD, why do so many people opt for...
  15. B

    Winchester model 67A 22 cal

    My was broken in half when I took it apart to see why it would not work. I have no idea how it happend. Because of the age it could have just been a strees crack that got worse over time.
  16. B

    Minimum barrel for maximizing .357

    Every thing said above is pretty much right and spot on. All of us have different needs and tolerances. I suggest you go to a local range and spend $50 to $100 and shoot 357 mags and 38 specials out of a 2,3,4,5 and 6 inch 357 caliber gun. You can then pick the right gun for you for a...
  17. B

    Winchester model 67A 22 cal

    It looks like a very old worn part from an orginal gun. Keep in mind I am no expert on these types of things, but I know it works great. Thx for the connection RC.
  18. B

    Winchester model 67A 22 cal

    Got the extractor today and shot the gun all afternoon. Great service-I recived the part 4 days by US mail. Classic Firearms did a great job for me!
  19. B

    308 and accurate 2230

    Looking to load a round with 43 grains of accurate 2230 under a 150 grain Barnes or Hornady copper bullet to get to approx 2800- 2850 fps. Has anyone loaded anything like this if so how did it group? Live in central Cali ( condor country) so I have to load copper for hunting. Looking to hunt...
  20. B

    Winchester model 67A 22 cal

    You may be right it could be a repo. We will see I already ordered it. I am not a collector so I don't have any safe queens. As long as it works that is all I care about. I will let you guys know when I get it.
Back
Top