Search results for query: *

  • Users: d163
  • Order by date
  1. D

    SA Revolver just fits?

    Ruger Blackhawk plow handle fits my hand perfectly. I can thumb cock it one handed pretty easily and efficiently. I can't thumb cock a large frame Freedom Arms with Bisley style grip one handed. Just can't reach the hammer with my thumb.
  2. D

    Forster case trimmer identification

    Thanks. That helps. As a side note, I think the choice of model names is kind of funny. In my mind, Classic and Original are synonyms (both meaning "the same design as the one we built way back then").
  3. D

    Forster case trimmer identification

    I bought a used Forster case trimmer. I was trying to figure out which collet and pilot I need, I learned the Original and Classic models use different (incompatible) sets of collets. So, I need to know if my trimmer is an Original or Classic model. I couldn't find either of those words on...
  4. D

    44 special derringer loads

    I'm buying a Bond Arms Cowboy Defender. It has a 3 inch 44 special barrel and comes with the small grip. It does not have a trigger guard. The small grip actually fits my hand pretty good, but I'm figuring I will make a longer grip that lets me get all my fingers on it. The Bond Arms...
  5. D

    .32 cal.

    Starline 32 H&R Magnum brass CCI small rifle primer Rainier LeadSafe 100 Grain Plated Hollow Point bullet 4.3 grains Unique Recipe comes from M.D Smith's reloading pages (http://www.reloadammo.com/32hr-mag.htm) I shoot this in a 327 Blackhawk. Knocks down metal plates at the handgun range.
  6. D

    Really Really stuck cases. .32H&R/Fed Ammo

    It's hard to double charge 32 mag with Unique powder. My cases are nearly at capacity with 100 grain plated hollow points. A double charge would not fit with room left for seating the bullet. I'm using Rainier bullets seated so the over all length is right on the max for 32 mag. I'm using...
  7. D

    Python came back from Colt with canted barrel

    >> BTW to the Ruger owner: The barrel shoulder is lathe turned back, not the frame ! Yeah, I know. But I don't have a metal lathe. The front of the frame looks a little rough textured. I'm just going to polish it smooth with 1000 grit sand paper. I'm not taking a grinder or other carbide...
  8. D

    Python came back from Colt with canted barrel

    I have a Ruger Blackhawk 327 with this same issue. Obviously (due to caliber) it was built in the last few years. I bought it used at a local major outdoor products store. It is my first handgun. I didn't notice the front sight was way to the right until days later. I checked as many...
Back
Top