Ok guys the bolt in my pietta made 1851 engages and locks my cylinder just before the trigger locks. Is this normal? If not how do I adjust it to lock at the same time as my trigger or atleast after my trigger locks? Any ideas would be very helpful as im stumped. I keep looking into the action...
I have recently put a new hammer and a new bolt in my 51 navy. I would like to make sure I have the timing concept correct so here goes. Pull the hammer the bolt shoots down out of the bolt window cylinder turns until the trigger engages in the half cock.Pull the hammer back toward the full cock...
I recently broke down my pietta 1851 navy civilian in 44 to clean the action parts. I have place everything back and it works fine , the cylinder turns the bolt goes up and down and everything just like it should. However when I put caps on my cylinder the hammer wont go down far enough and it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.