Search results for query: *

Done it before with no problems, primes need a fast sharp impact to go off.

I was going to convert a tumbler to a paint shaker for model paint, now I think I'll just make me a paint shaker.

Anybody have a favorite .303 Brit powder. I'm currently using using R-P brass, CCI200 primers, Speer 150gr SP and 40.0gr of IMR4895. I'm shooting low with this load, so low I need to set the rear sight at 500meters to bring it up to give enough elevation for 100yrds. BTW it's a No.4 Mk.2...

Start reloading.

Marlin 39A, thread finished.

All but 2 or 3 of the guys I shoot HP with use w784.

W296

Marlins new bolt action rifle the new XL7

The Savage 99 works upside down:D

It falls out the open top of the receiver on the Winchester.

Wilson's 7 or 8rnd

How were they different?

Yes, the lower impulse pressure makes life a lot easier for you and your rifle.

Pigtail Gas tube

FYI -- 3100s grain size if bigger then IMR4895, longer and thicker. It looks about the same as IMR4350.

I guess I'm lucky, my Walmart still has guns, ammo and reloading supplies. The only stupid question any of the staff asks if for my money after they ring up the sell and get mad at the register for asking my age. :D

Ok, maybe I'm not that pissed. I started loading .243 Win for the first time today, it started well, 50 new Remington cases (bag had 51 ) FL sized with the new Lee Pacesetter set. I ran the cases in the tumbler for about 2 1/2 hours, primed them with the RCBS handtool (that's when I...

Nice little shooter.

Local Super Center has reloading supplies and fudd guns :neener: I buy a few things, dies and bullet prices are ok, powder's high. I get corncob there sometimes and reload manuals some brass (.223)

Newer Accurate load data, no Hornady 150gr., but they are showing only using WLR primers no LRM. You may want to switch to 2460 or 2520, both of those powders are better suited to the 8x57mm Mauser.