Search results for query: *

Anyone reload 7x75 vom hofe super express

Would like to have a ruger old army re-barreled into a buntline any info on who could do the job?

I'm looking at a nice 1859 sharps carbine 52 cal.percussion Anyone know where bullets or a mould are available.If I buy it I want to hunt deer with it

does anyone sell kaido cast bullets?I would like to try some as a hunting load in my ROA before thinking about buying a mould

I'm wondering how much difference there is in performance between a Dave Clements 50 cal and just having the cylinder rebored on a standard ROA to hold more powder?Would there be enough difference to justify the cost difference?

Rare model ROA for sale on gunbroker.There is a nice 1st year production flat top front sight model with original box going off toay.I have mine otherwise I'd be all over it.There was less than 800 of these made.

I just recently purchased a brass frame roa which had ugly rubber grips on it.I contacted ruger to find out which grip pannels it uses because they are about 1/2" longer than normal.They gave me a part # to get them from numrich which turned out to be wrong.I called them back and they not only...

while I was gone this winter I bought a roa brass grip frame on GB and had it sent home.Now I'm home and the brass grip frame is not the same size as the normal roa.Now that I guess I'm stuck with it I want to at least get rid of the rubber grips and put wood back on.The grip frame is close to...

anyone use a uberti 1858 carbine for hunting?what's your favorite load?

Does anyone know how much more powder a roa cylinder will hold after Dave Clements drills them out?

I understand the very first 800 ROA's were flat tops{front sight}some of which were blued and some brass frames.Anybody know how many of each was made.?

has anyone contacted belt mountain lately?I've called a couple times and they don't answer the phone.

I have a walker I no longer use and am thinking about getting rid of but first I need to know if it has a big problem or a minor adjustment.When it is on full cock you can pull the hammer back more and the cylinder will turn a little bit so it will not be aligned properly.Ideas?

Just heard back from ruger about my request for service on a ROA.I heard they still had some parts but only used them on service they preformed.They said no parts or service on old armys anymore.Too bad.

I just got a ruger old army that seems to have the base pin bent.I can't remove the cylinder.The end of the base pin looks lower than on my others.How can I remove the pin.