Search results for query: *

I'm buying some bowling pin bullets from Penn. they have a 230 gr. "thunderhead" which is essentially a very long wadcutter for .357 which is designed for this purpose. On their site they say to use 9.0 grains of Accurate Arms....no mention of which one, though. Here's a link to the site...

Last time I shot IPDA with my revolver, I got nailed because I brought some min. power factor loads (just over 125) and they had all steel targets (it was raining, they didn't want the paper to melt). Took 3+ shots to knock down some of the 2' tall poppers. In .38 or .357 what should I load...

I have a used (new to me) Dan wesson mod 15 (.357) that I have replaced the hammer spring and trigger return spring with the Wolff reduced recoil springs and replaced the grip with a Hogue monogrip. No other changes. Since these changes were made, the cylinder stops and will not rotate after a...

Anybody know of one? I have e-mailed both Galco and DeSantis and both of them have replied that they do not make one specifically for the Dan Wesson mod 15. Maybe a holster made for the S&W that is close? Goog

I've been having a problem with Remington Game Load shells in my 16 ga. 11-48. About one in 10 shells will separate at the head, leaving the plastic case in the chamber and brass head on the ground or just in front of the bolt. I was at the range yesterday when this happened and was told to...

Anybody here tried Blindhogg's hot blueing recipe? http://www.blindhogg.com/homemadesalts.html goog

I posted this on Sixgunner and the post has grown cobwebs and gotten lonely. anyone here done a trigger job on a Taurus revolver? My understanding is the mechanism is based on the S&W, but not identical. There are instructions out there to do a trigger on a Smith, I'm wondering if I can...