Search results for query: *

Anyone know if the 38 super brass is any different from brass marked 38 super +p? Is it like the .38 special and .38 special +p in that the only difference is the head stamp, to keep one from putting +p loads in a gun not rated for it? I wonder because Starline has different prices on the two...

Options, all Smith & Wessons: (1) Model 66 (no dash) in 90+% condition, $650, or (2) Model 15-3 in 90% condition, $550, or (3) Model 64-8 in 95+% condition, $400. My Blue Book is a couple years old, and all three prices are about $150 over the listed prices, but then nothing is going down in...

I recently bought a box of Bayou's 150 grain 9mm SWC bullets. Anybody have any experience loading them? I'm interested mostly in comments about OAL, given the rather unconventional bullet profile. Seems to leave VERY little space in the case if one seats to a depth where the SCW shoulder is only...

S&W Model 66 (no dash), 4", very good condition, I'd estimate 90%, $575 or S&W pre Model 10, mechanically sound, but someone had it chrome-plated, $350. Either of these a reasonable deal?

Any idea why Alliant's web site says that Clay Dot is made to mimic Hodgdon Clays, but then at the bottom of the page, in small print, it says "not for use in metallic cartridges"? Clays is one of the best powders I have used for target loads in .45 auto and .44. It would be nice to be able to...

Saw a S&W 30-1 with box, in pretty good shape. I'd estimate it to be about 95% condition. It's been used, but not hard. 2-inch barrel (32 S&W long). Price on the tag is $399. I can't find many sales for this model on the auction sites, other than a few in 99% condition for $800 and up. Any...

I have a Smith 632 in .327 Federal Magnum. It's pretty accurate with .32 H&R and .32 Long ammo, but the group opens up a lot with .327 ammo. Not sure why. I've used factory semi-jacketed, lead and hi-tek coated lead, and they all lose accuracy when loaded for 327. Is the bullet just being...

I have a Smith 67-1 with square butt and am going to change out the stock wood grips (which slip in my hand) for some Hogue or Pachmayr grips. Any suggestions on which to get?

Just bought this revolver used, bore is mirror-bright, cylinder is tight, some exterior wear (mostly fine lines from cleaning/use, and some rounding of the outside edge of the barrel at 3 adn 9 o'clock which I assume is from holstering. I'd put it at 95% condition or so. And it came with a...

Any reason why one couldn't use a carbide 9mm sizing/decapping die to resize 22TCM? Both shoot from the same chamber. It wouldn't size the neck, but does it need to? I'd be reloading only cases that came out of my own gun. Do I need to resize at all? Or can I just use a universal deprimer...