Search results for query: *

that is, wax, oil and etc. - will not spoil powder in the case ?

Ok, I'm ask - these wax rings are in direct contact with powder in case. This is bad?

)) I thought Wad Cutter is a lubricating wax ring (rings) around cast lead bullet. My bullets is cast lead, and powder in the case may touch to bottom wax ring.

what about handguns?

.. it is bad for powder or something else?

If stay set the bullet against the rifling , what happens? (OAL unchanged before and after extraction)

If due to bullet seating depth, wadcutter (beewax+petroleum) is below the neck inside the case(rifle case) - it is bad?

I'm sorry for my brainstorm :) )) In step 10, there is no error?

Rifle. Never been use barrel But 2 in 1 die. Question. Proper settings seating die : ...., -.003, -.002, -.001 ...+.001, +.002, +003, .... inches, relative "rifle (handgun) seating depth"?

Please tell me how to adjust bullet sitting depth for my chamber "personaly", simply step by step correctly!? (for example: 1 step...., 2 step....., 3....., and so on ) Thank's .

Lee selling their kits with .002" accuracy. So, lottery ? ))

That is, jacketed bullets .001" and cast lead bullets .002" more than bore _ this is ok? (at least for a handgun)

Hi. What is the proper difference between barrel and bullets diameters (Cast Lead, jacketed bullets, etc.)? If not proper- what consequence? (overpressure or something else?) (for example, .3550" slug and use .3565" cast lead bullet)

Who used gas check and lubrication for handgun cast lead? what materials and why (wax,paraffin,wax+oil, or etc.) ?

I mean wad . Something about load reduction.

Why use a wad in handgun cartriges?

But how data is calculated from the beginning? Some guy has calculated PSI for AA loads only ?! How to calculate the PSI for Alliant? ( may some calculators?)

Just a question. Nylon hard like a steel! Teflon is soft as copper and slippery.

But which one plating way? Electroplating?

For ACCUR#2 ,5, 7, 9 are there analogues from Aliant ?