I have 1K small primer 1X fired Federal 45 ACP I want to reload with 230 lead RN from Lee Mold for mostly near full house loads. I have CCI small primers and TiteGroup plus most other pistol powders to use. I do not want to crush or render brass to crematorium as recommended by most. This is a...
Should I be using a (small base sizing die) for my accumulated 1x fired brass. I am loading for a Ruger #1 and a modern single falling block Browning high wall all in 7mm Rem. Mag. I get my brass from my friends who shoot new clean excellent condition modern firearms so I know 1st hand where it...
Do these vintage Weaver scopes meet the same specs. as some of the newer middle range priced hunting scopes? Will these scopes in pristine condition stand the pounding of severe magnum use as I am looking for scopes to be used on 7mm STW, .416 Rigby, 30-378 or firearms with these recoil figures...
Looking for individuals with experience using 154 to 162 grain bullets with high ballistic coefficient. I am looking at whether it is cost effective to invest in the 7mm STW for the extra couple hundred feet per second for the heavier bullets? Looking at slower velocity to save barrel but gain...
I am looking for internal trigger/hammer locking flat spring (it is one of the flat curved springs that is broken) mechanisms for a CVA 54 Caliber BP Missouri Model Rifle. I picked this up in fair condition to rebuild for my "common-law-son-in-law" knowing it had this problem, however, I did not...
Hello, I am new to the forum and one of your members told me about "THR" so I joined and have been reading many categories with great interest. 16 years ago the "City of Belle Fourche", SD passed city ordanances that ran the last gun show out of town. It has been my wife and I a life long...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.