Got tired of the 1050's primer catcher and the 223/5.56 brass cutoff quick mod as large primers would get stuck on its mouth causing issues, so here is what I have as a solution. Anyone else have a similar solution?
Here is a little something that I came up with to remove/install the Dillon 650's primer assembly. Anyone else have troubles with the placement and access to this priming assembly?
Has anyone had issues of primers not seating due to dirty primer pockets?
Pros/cons?
Is it "proper" to clean them or is it just for "bench rest shooter" type accuracy and precision loads?
Just curious to see what people think in "general". This may have been covered before...
Curious of those that own Dillon Super 1050s, what is the average toolhead spring life before spring fatigue or breakage you are getting? I am getting an average of 20k cycles per spring which for me yields 10k rounds since each piece of brass goes through twice, size and trim...cleaned using...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.