Search results for query: *

I meant this http://www.walmart.com/ip/Tetra-3-Whisper-Fish-Net/20631638

I see what your saying & I like tools also. Just saying for me. I can feel when a primer when is lose.

Well if you could get her to hold a fish net. Place a big piece of cardboard beside her. I just pick mine up off the ground when I'm done.

I hate the search function on here but this one is getting beat to death. Looking over the first couple of pages usually shows this topic. Anyhow enough said by me on this one.

Pretty much how mine are done. My die is set low enough to fix any belled out to far but most are never touched.

I see the brass all the time. Even known people to willingly fire 9mm in 40 cause it was cheaper. By the way people are stupid. I seen a video somewhere of a 223 being fired in a 9mm. The pistol had to be assembled around the round.

You can also put just 1 round at a time in your AP & run that 1 round from fired to finished. I have used my Pro1000 to load 243 & even 30-06. I drilled a hole in the turret so it didn't auto advance & I'd rotate the shell plate at the bottom of the stroke. It is a great press to load 45ACP on...

For about 2 cents I get a primer & seat it. I guess if one fails to seat I'll be out 2 cents but that wold have to happen 500 times to pay for the tool.

Sorry but ROFLMBO.

Well I think Remington makes fire crackers because they shoot like crap. I don't think Federal is much better. But at one time I shot Hornady in my 30-06 & it shot same hole so close that it was hard to tell there was more then one shot at 100yards. It shot 3" at 300 but my scope wasn't great...

410 has been expensive since I was a kid. Why I bought my first 12 gauge. I could get 2 boxs of 12 gauge for the price of a box of .410.

This comes up once a week now doesn't it?

I'd like to see a picture to know what your looking at.

Looks like front to me with a place to mount a tray. Congrats

I have the same findings as 1K. I didn't use epoxy but instead pressed a piece of plastic in a larger hole & bored it to size. The bushing can be easily removed. Altho I did get decent consistency by swaging some brass to take up just a small volume but got tired of adjusting & trails & just...

Yelp. Remember this is a good will thread & not a bartering thread. ;)

"shyster" Really? The OP has said that this is seconded handed info that he doesn't quite understand his self so that is a pretty harsh word.

What the 380 is would be helpful info too.

Dang! She has me wanting a 410 press again.

If you can get the MEC for the .410 I'm sure he would love that. I know I would.