Not unethical. Depending on distance and load. It could equal many high power cartridges. Including a 40 yard shot would equal a 400 yard shot with a 45-70. Honestly only thing unethical here is your knowledge of ballistics.
I do both. Hi-tek coating instead of pc. The pc or Hi-tek are better almost all the way around. The only thing I lube anymore is 45 colt with pan lube. Dunno why other than old school vibes.
this.
lead at the beginning is fitment and obituation.
leading at the end is a lube issue.
also 18BHN is to hard for any pistol bullet short of 454 casull pressures.
I have no idea why bullet manufactures do this.
i run 16BHN bullets coated with Hitek at 2400FPS in a 7.62 rifle. any harder...
no 45 super is going to cause injury. Its still less than a proof load for standard 45acp. it will accelerate ware. that is all.
they are identical between the 10mm and 45 super for most all comparisons.
They make a special lube for this already. Its expensive.
Read a few things that it smells and feels similar to wd40 only its tinted red. This is a must I guess after a sonic cleaning to prevent rust in areas you cannot get too.
For price reference a gallon of the hornady or lyman cant...
I was wonder if anyone Uses WD-40 after cleaning a gun? Just to displace the water.
My idea is to clean the gun. Then WD-40 the gun in the ultrasonic cleaner. Let dry then lube with normal type gun oil as usual.
Mag primer. Find a powder that fills the case more. Tighter crimp. I run a 158gr. +p at 1004 fps out of a 2.5" revolver. And 946 fps out of a 2".
The only way to get single digit sd #'s it to up the pressure or go with 3f black powder.
You would be surprised at the black powder consistency...
A bit late on the follow up. Hit a whitetail doe at 180~yards. Went well. Bang flop. Good exit hole with plenty of damage. Could not recover bullet.
Definitely have a true winner in this setup.
highly unlikely. the deflection of a fmj round nose and the slow velocity of the 380 out of a short barrel would not be a good combination at all. if it is anything but perfectly square on impact it would likely defect and not penetrate. even the 44 mag has a hard time at less than perfect...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.