Search results for query: *

I see on the SAAMI website that the specs for .223 Remington case length is 1.760 -.30 Does anyone really load cases as short as 1.730? Just curious. I normally don't use anything below 1.745 or longer then 1.760. I trim the long ones to 1.750. I would think you might start having neck tension...

I picked up some Xtreme 9mm 115 gr RN bullets today. Going to use them in my M&P Shield. Does anyone have any load data that would be a good starting point for theses bullets in a M&P shield? I have access to 700x, TiteGroup, and Bullseye. The OAL data is most important to me. Thank in advance.

On the primary arms 2 MOA mini microdot Does anyone know if it's 1 click = 1/2 MOA at 100 yards or 50 yards? I'm guessing it's at 100? The book only states 1 click = 1/2 MOA. Thanks.

Is it me or is Hornady load data a bit on the conservative side? My 9th edition manual shows 23.2 grains of H335 under a Hornady 55gr fmjbt projectile. I see some loaders loading up to 26 grains. Also what are your Hornady 55gr fmjbt over H335 ? Would like the input. Thanks.

Started using Bullseye for loading .45 ACP 200gr LSWC loads. I had been using Hodgdon 700X for some time but heard Bullseye was a better powder. Seems like the 700X was working better for me and I am not convinced. I would like feed back on your thoughts on Bullseye and what caliber and load you...

I am new to shotgun reloading. However I do reload a lot 0f .45 ACP. I can not seem to get a direct answer on this one and I have called all the manufactures of all the components that make up the load I am trying to accomplish. The question is... Can a Federal 209A primer be substituted for a...