Search results for query: *

Looks like your support hand fingers will be awful close to that cylinder gap :eek: Will Korth Finger be the next Garand Thumb

wow...good shootin. and some good data. thanks!

Thanks a lot...I will defiantly pick up a copy I have been loading cast bullets in handguns for a whole now, this will be my first time trying cast rifle loads

Thanks! Any chance you could share the specifics?

I have a .308 mold that drop 160gr bullets. I want to load some of these in my fr-8 Mauser. I have some Reloader 7, 3031, and a little but of 2400 on hand. They will be gas checked, and cast with wheel weights. Not looking for super light gallery loads, but I would like them to be hot...

I was shooting + p loads. Tried some more today...same issue. Switched to standard velocity loads and the problem went away...odd. Yes...it's a RocknRiver upper and it came with a bolt. It's defiantly not short stroking

I recently bought a RRA 9mm upper for my AR. The rifle has functioned normally through sever hundred round before the upper swap. In 9mm configuration I basically have a single shot. The rifle will fire, ejects, and loads a fresh round, but the hammer follows the bolt forward. I have the...

http://m.hornady.com/store/Steel-Match-handgun/

I highly doubt any manufacturer of automotive wheel balancing weights would recommend My preferred use of their product as bullet casting material...

well I dont! where I shoot EVERYONE reloads and we also have a few brass scrounges who come by almost every day and sell what they find. I find .223 brass by small handfulls at best. its just nice to know that on the days I dont find a small handfull of brass, that I do have a viable option.

Thx archangel If only wolf 7.62x39 was boxer primed.

Steel can be reloaded. I have been doing it for years. There are a few caveats however. - .223 is the only steel case I have found that uses standard boxer primers - you can't use lacquered cases - you can only reuse them once - the steel is a little harder to size and may accelerate...

Im near Columbia SC and wondering where to get my SBR engraved. I would really rather not walk into Things Remembered with a "bushmaster assault rifle" lol Anyone know of a place around here that does laser engraving and is farmiliar with firearms?

Has anyone experimented with Superformance in the .308?

Thanks!! That helps a lot! At least I don't have to make fireworks out of it :-) Gonna make up a batch with some Barnes 150's later Thanks guys

my normal powders were sold out today so I picked up an LB or Hodgdon Superformance. I have used Superformance loaded ammo in .308 and .223 so I figured I would give it a try. I found out a little too late, that the powder is not the same as used in their loaded ammo and load data is only...

Christmas money is burning a hole into pocket and I want to finish a .300BLK upper for my SBR registered lower. I'm looking for a reasonably priced barrel between 9 ad 10.5 inches that's in stock. I would like to spend around $150ish. I do t need anything special, it's just gonna be a...

Phil and his wife are good people. Before he started Innovative Arms, he worked as a Machinest for a big corporation with one of my Co-workers. When there was something they couldnt figure out, the went to Phil. He dosnt have a big fancy shop, but he does alot with a little. He makes a dang...

Cool. I can live with that! I made the corrections with a single strike through and my initials. I hope that's right.

Whoop. My patience is getting thin...I can't wait to finish building and shoot my shorty!!