Good morning.
I have a Springfield Emmisary that is giving me troubles. Using mixed brass with a 200 grain RN bullet, 147 grains of BE and CCI SPP. About every other range trip I get a squid with a slightly dented primer and unburnt powder spilling out of chamber and brass when I am able to get...
Hey Guys,
Am looking into expanding from reloading pistol rounds into reloading .223 and was contemplating having Santa bring me a Dillon RT 1500 Case Trimmer, and if there is room in his bag, to throw in a Super Swage 600.
Any downside to these two pieces of equipment?
Thanks for any...
I have a Glock 23 with a stock barrel. Today I was shooting 3 different loads of Bullseye at progressive distances. Temperature outside was 72F with a humidity level of ~60%. After 90 rounds thru the barrel I was out to 36' and could not hit paper. After letting the barrel cool down for 10-15" I...
I started out reloading 40 cal. on my Dillon 550B and with the help of this forum recently started to successfully reload .9mm. Now I am struggling to set up my Dillon dies to reload .223. I've got the station #1 sizing die adjusted, cases fit in the case gauge fine. But with station #2 I can't...
I have a Dillon 550 that I have been using to reload .40cal and .9mm pistol rounds. Have only used Bullseye and Unique powders. Do you folks find that Bullseye meters better with the Dillon powder measure than Unique does or is it just me? And, is there a powder that meters better than Bullseye...
Hello,
I have a Dillon 550B and have been successfully reloading .40 caliber rounds with no difficulty. Now when switching to 9mm. I had a problem come up.
Am using once-fired brass and Berry 115 grain bullets. Seems like I can push the bullets into the brass even before sizing the brass or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.