Search results for query: *

I am getting a bulge at on the shoulder of my 7mm Rem Mag cartridges after I full length resize them. I am using Redding dies. Some bulge some don't. I am using Hornady one shot lube. Is anyone having this issue or am I reloading cheap brass? I just bought 100 Norma brass which has been...

I have several pieces of brass the I have put slightly too much mouth bell on while adjusting my dies. I hate to waste good brass, but the bell is too large to fit into my 45 ACP sizing die. Does anyone have any suggestions about how I might resize the brass bell without ruining the case, or...

I just purchased a box of Hornday FTX 45 cal. .452 225 grain bullets. I have cut down some cases. I would like to reload some ammunition similar to the way that Hornady loads. I have a Marlin 1894 Cowboy and a original Ruger Vaquero with the large frame both in 45 Colt. I have the most recent...

I should have asked around before I ordered but I just purchased the Super Crown Crimper from Ballistic Products with some overshot cards to improve my crimps on my MEC reloader. Have any of you had experience with this crimper or using overshot cards? Any advise on using the crimper?

I have been asked to shoot on a team of my American Legion friends. We must shoot five rounds at three different distances in quick succession. I have a mid-seventies Sig Sauer P220 which I purchased after Vietnam. It has always served me well, when I qualified for the Division of Wildlife. With...

I was reading in a recent magazine about reloading accuracy. I have a tumbler and generally clean my shells, then neck resize, and remove primer. I then put the shells back in the tumbler to make certain the primer pocket is clean. I usually trim the brass to the correct length. I use...