I recently acquired a cz52 pistol and a set of 7.62 tokarev dies. I've begun reforming my large stock of spent 5.56 brass into tokarev brass.
I would like to load these with the cheaper M1 carbine bullets, but I can't find any load data for that bullet weight.
Any ideas for a starting point...
Yesterday I picked up a used p64 and 50 rounds of sellier and bellot 9mm makarov. During the course of firing I had two stovepipe malfunctions. Should I change out my recoil spring? Is the S&B ammo just not hot enough?
So I am acquiring my grandfathers Remington 511 rifle on my C&R. Is it possible to mount a scope to these? Also the stock is pretty beat up is there any good source for replacements?
Assault weapon double think
https://www.bostonglobe.com/opinion/2016/07/20/the-loophole-mass-assault-weapons-ban/eEvOBklTriWcGznmXqSpYM/story.html
So apparently Massachusetts is changing what qualifies as an assault weapon in their state. Interestingly, in this article by the state attorney...
So it looks like my drivers license is going to be suspended since the court where the fine was issued never received the check I mailed them and the bank will not issue another one until 90 days have passed.
My question is, according to Florida statute:
What constitutes "valid...
Does anyone know where I would be able to find a replacement stock and handguard for a M41 Carcano?
I've checked Sarco and Liberty tree collectors with no luck.
So currently the new talking point of the Antigun movement is adding people on the no-fly or terrorist watch lists to the NICS prohibited persons list. This has understandably caused a lot of outrage, but what about other categories of prohibited persons, namely users of controlled substances...
So today I was cleaning the trunk of my car and noticed I had spilled some laundry detergent had gotten on the side of my shooting bags. Since I was doing laundry that morning anyway, I had the stupid idea to put them in with my wash. After taking them out they seem to have absorbed water and...
Since I started reloading, I have been considering getting a revolver in .45 ACP and possibly getting rid of my .38 special so there is one less type of ammo I have to reload. When I was inspecting some 7.62x54 cartridges I had just tumbled and finding one with a split mouth this got me...
Has anyone had success reforming cases to 7.5 Swiss? I've noticed the .30-06 has a similar rim diameter. Can .30-06 be reformed to 7.5 Swiss with trimming? The case is a little thinner, could it be fire formed?
Does Hornady test these with actual brass?
I recently purchased a Hornady #21 shell holder so I can start reloading for my carcanos. After a long hassle with the post office, I finally got it yesterday and this morning was going to deprimed all my brass. However, none of my 7.35 or 6.5...
I have a 1911 that I made from an 80% frame which fairly often doesn't feed rounds completely into the chamber. When this happens I can always just push the slide forward and the round seats completely. The pistol never had problems ejecting. I'm wondering if it needs a stronger recoil spring...
I recently acquired a Finn marked 7.35 carcano at a local gunshot. After looking online it doesn't seem that any one manufactures ammunition for it. Does any company make reloading supplies for 7.35 carcano, or have I essentially purchased a wall hanger? If it is possible to reload, what would...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.