i have a rem 700 in 30-06 set up with a picatinny rail and high burris ext. tac. rings which lets me shoot left handed and use my right eye. it also provides a good cheek weld and the 06's recoil is not a problem.
Captn.the way the hp game king is shaped the bore diameter on the ogive is closer to the point of the bullet meaning it is probably seated closer to the lands than your previous bullet. try seating deeper in small increments if you don't have a bullet comparator to match the 120 gr. loads...
take a 7 inch from the base piece of deer antler about 1 inch diameter cut off. leave the brow tine. about center put a screw eye in and
attach part of a metal fish stringer. the ones that work like a safety pin that you stick through the bottom of the fishes jaw. sharpen the point. when you...
i had an a-bolt reamed to k-hornet and at the time gave the gunsmith a set of wilson 22 hornet dies and had them reamed to k-hornet. neck die and seater. necks and seating can be done with the heel of your hand on a table top. no press necessary. one nice thing about the hornet case being so...
German made. kleingunther in texas used the voere receivers and or barreled actions and sold sporter wt. hunting rifles with an extreme accuracy guarantee back in the 60's&70's as i recall
yes the #6 set is the one for the h&h case head. when starting with a new to me rifle i start with the # 10 and progress to the holder that gives the correct shoulder set back, checking with the head space comparator and make a note for which to use with that rifle. sometimes different brass...
a couple of things that will really help with full length sizing and also trouble shooting any problems you run into with case fit. a set of redding competition shell holders and hornady head space comparators. with the comparetors you can measure your fired cases and use the shell holders to...
your seater. the belt does enter the sliding chamber. reddings instructions are this: raise the ram to its highest point. screw the die body down to the point the sleeve is compressed to the die body. back off one turn, put the micrometer marker where its easy to read. Redding says jamming ram...
take something like a 35mm film container& fill half full of lead bird shot add some imperial dry neck lube[ powder graphite] and stick the necks in a couple times
just cut it off on a grinder or with a dremmel. might need to work the threads a little with a small file. if the end is square it is a little difficult to get it started but once its in you are done.
ive found accurate #9 to be a very good 44 mag powder. target is important like dog soldier said. i make a target for bead open sights with a bulls eye that the bead gives a good aiming point so that i can center the bead easily on the target and some reference marks on the target so i am able...
Morrey i have seen this work many many times. i use sierra bullets .010 off the lands. fed 210 primers and h4350 powder. start with a safe charge of powder and shoot paying attention to pressure. as you increase the powder charge the groups should tighten. i've had 3006 rifles that would not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.