Hi Guys,
I've been here to ask questions and lurk so I figured I'd share some data.
A friend of mine recently purchased a Savage 10/110 BA Stealth (https://www.savagearms.com/firearms/model/BAStealth) and I've been helping him work a load up for it.
A case gauge along with trial and error...
Swapped out tool heads on my 550 today to load some 223. Loaded the powder funnel with CFE-223 and then some in the RCBS Chargemaster. Wasn't looking for anything special, just wanted the gun to cycle and have some plinking rounds. Worked up using Hornady's load data with the chargemaster and...
Its beginning to get cooler here in New England and with the shorter days finding time to dry brass with sunshine is going to be tough.
Has anyone used the Hornady Dryer or another that they'd recommend?
Hi Guys,
Couple more questions for you...
I'm using Hornady's 9th Reloading Manual for 9mm and have tried 5.1 and 5.4 grains of HS-6 with mixed brass, Winchester Small Pistol Primers and Hornady's 124 grain XTP bullets seated to 1.06"
Issues: In my Glock 34 Gen 3 the slide is not locking back...
Hi Guys,
I set up my Redding 9mm dies (88172) on a T7 and after resizing I am getting a ring where the shell plate and die meet. The die is making contact with the shell plate. Is this brass still ok to use? It's blazer and other cheap stuff.
Also, after seating my bullets (test round for...
Hi Guys,
Gosh, I'm searching but cannot seem to come up with the information that I'm looking for. I'm trying to find the bullet diameter, B.C. (G1 or G7) and length for CCI 40gr Standard Velocity.
This is basically just a science project to use my Kestrel and practice milling with the ability...
Hi Guys,
I can't pull the trigger on a Wilton because I'm between two models in the machinist (bullet line) the 350S and the 450S. I then looked at the Trademans and am not sure of the difference... I'm really looking to "buy once, cry once" here but need some help. Any input?
Hi Guys,
I've been going nuts on trying to decide on a gun locker. It seems everything is a trade off and I can't find what I'm looking for.
I like the idea of Secureit's Fast Boxes ( https://www.secureitgunstorage.com/product/hidden-gun-safe-model-47/ ) and Model 52 (...
Hi Guys,
After finding some CCI #500 Small Pistol Primers in stock tonight I'd like to have someone double check my thinking here:
I plan on using the following:
Starline Brass
CCI #500 SPP's
HS-6
Hornady 9mm 124gr FMJ RN Bullets (http://www.hornady.com/store/9mm-.355-124-GR-FMJ-RN/)
Lyman's...
Hi Guys,
I've read somewhere on another forum maybe (can't remember) about a modification done to a media separator for separating stainless pins and brass.
The mod was essentially a strainer that could be bolted to the bottom of the separator which controlled the draining of the water...
Hi Guys,
Initial post here so please be patient. I've done a search and read the initial Lyman section on "following a recipe" etc. The thing I'm struggling with is that when I look at most recipes they state winchester cases etc. but I see starline and "brass guys" cases for sale and I'm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.