Search results for query: *

half cock was the safety when the hammer is in that position it blocks the slide from moving rearward and the trigger cannot be pulled

I thought about bobbing the hammer and putting an adjustable rear sight on but came up with two possible issues that could potentially arise; 1 the lower hammer mass may not have the "uumphh" (for lack of a better term) to set off the primers found in some of the surplus ammo. #2 and the reason...

yes they did, took some minor fitting on the grips and hardware to give it the clearance it needed but the are tight and look great.

I was going to fill and weld the hole but i decided against it. the safety isn't in a terrible location it just looks ugly

I actually found them on eBay, turns out the seller has a business here in Georgia making grips for all sorts of surplus pistols. Tillander gun grips is the name of the business

Hi All, I Am a new member Stationed at Fort Benning GA. I have been gunsmithing for several years. I graduated from TSJC in 2014, I currently am a gunsmith in the ARMY Marksmanship Unit building pistols. I love the information on this forum and am honored to be a member.

Hello all, I am new to the forum and thought I would take the time to share some pics of a Tokarev I recently built. It Started out as a TT-C Romanian, lots of work went into jeweling the trigger, hammer, barrel hood, and bushing. I put in a norinco chrome lined barrel and cut new dovetails...