Search results for query: *

A friend asked me to repair his shotgun, had a broken firing pin. Looked and found the pin was obsolete, also found a bunch of people looking for them. I took a chance and ordered one for a different model from Numrich. #1419080D. I had to hone it down a hair with emery paper, cut back a bit...

Looks real close. the latch is on the left side and there defiantly is a forcing cone about 3" in.

Fairly certain its a 410. Strange i can't find one like it anywhere.

Hello, I saw a shotgun this weekend. Appears to be a .410 single shot. There is a small lever on the left side of the receiver. You push this down to open and the barrel swings to the right to load and unload. The only mark I saw was the E over LG over a star in a oval. No Crown. From what I...

I have always been real sloppy regarding used brass, maybe this is a wake up call. I have cast and reloaded literally thousands of 45acp, 9mm, 44mag. I have had split cases that I only found when I went to reload them, but these are the first case failures. I'll do some experimenting this...

thanks, I'll check the notch higgite. ya know, Linux Mint, I'll give that a whirl. I usually load my own lead which I run through a lee sizer at 356. I think all of these were factory fmj that are 355. they seemed to be tight but this gives me something constructive to look at. So if they...

Hello, have loaded 9mm with 4.0 gr of 231 with 124 gr RN until I lost them or the case split at the bullet end. Never had an issue. Mostly fired them in a pt111 or a ruger p89. I acquired a Berretta 92fs the other day and had a case fail at the base. It had a rectangular hole in the base right...