Search results for query: *

Are you throwing a charge or trickling a charge. Throwing a charge i just put the pan against the bottom of the of the powder measure and then lower the pan and give the measure a tap to drop the little bit sticking in the tube. Never had a problem trickling.

No i do not yet have a chronograph. Saving for a magnetospeed v3

Would you use a heavy crimp then to avoid bullet setback or just use my regular light crimp

This is my load book, very different for oal lengths. Sorry for the glare This is the bullet at 2.20. I would not feel comfortable using this length in an ar due to lack of contact between bullet and neck of case

I am guessing the 147s are m80 pull downs. What oal do you use, if you have the number handy

I have check weights

2.090 is the oal in the hornday 10th manuel. My guess for this length is so the bullet has full contact with the length of neck to the shoulder.

Formed LC 16/18

2.090 is barely to the cannelure and is what hornady has in their book

No

Grabbed 10 random and all measured .330 or .331. I use cci 400 in all my 223 loads without any high pressure signs.

I am new to 300 blk. Just built a 9in pistol with ballistic advantage premium series barrel. I am using converted LC brass with a cci 400 primer and 15.0 grains of h110. Hornady 150gr fmj loaded to 2.090in. Major pressure signs, flat primers and ejector marks. Tried 2 different bolts and same...

http://bulletin.accurateshooter.com/2017/10/stop-neck-sizing-why-you-should-full-length-size-your-brass/ Here's an article on why you shouldn't neck size brass.

I was just wondering if anyone knew cause it wouldnt be for pressure reasons so maybe hangfires or misfires

What would happen if anything if i would use h4895 and go below that 60% point, say down to 50% at 18.5 grains

I am looking for some loads with 100-120ish gr bullets that are between 1800fps and 2000fps. These will be jacketed 30 carbine bullets so no need on leading crap. I just need something cheap cause the earth wants its lead back. Thanks in advance

You guys have any very reduced loads that can extend barrel life

Hi point did it so I'm sure that ruger can too

My shooting range is my back yard so they will sit there forever

Do the targets ever swing or bounce off the the hooks or do you bend them closed