The only thing I would add is to trim the straight walled .38 and .357 magnum cases if you want a consistent crimp. I would do this right before expanding the cases. I also think the lee hand prime tool would help you not have to touch the primers.
Before I load a cartridge, I ignore the label on the box of projectiles and weigh a few as well as check the diameter with a caliper. Trust but verify!
Folks, does anyone know where I could purchase projectiles for the M855A1 Enhanced Performance Round (EPR)? I am loading some .223 and am looking to experiment with various projectiles. Also looking for some tracer projectiles for .223. Thanks so very much in advance!
Folks, does anyone know from where I may procure just the projectiles used in am855 “green tip” ammo? I would like to load some up and test them compared to my Hornady 2267s. Thanks so much in advance!
Folks, I have used Hornady 2267s (boat tail with cannelure)in the past, but am having a hard time finding them in quantity.
What are your recommendations for 55 -62 grain .223 plinkers? And are they available in quantities of 1000? Thanks in advance!
When you get your drop to weigh close to what you’re looking for, dump five loads into the pan, weigh them, divide their total weight by five, to get you a good average of your single drop weight.
RMR shows them, but when you attempt to add them to your cart, you get the message that current quantity is exceeded, so you are out of look! Thanks though, fir the suggestion!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.