Search results for query: *

Have any of you guys used the Lyman MSR Precision three die system for 300 blackout? If so, what kind of results do you get? And would you recommend them or something else other than Lyman? Thanks

You Sir, are one organized fella! From one woodworker to another great job!!!

I also wet tumble with the Extreme Rebel Tumbler Sometimes I remove the primers other times I do not. And I also recently discovered the very best way to separate all the stuff at the end of the cleaning cycle...

Thanks again Guys, lot's of great suggestions!

Well, I have waited a long time to do this. I have loaded with Lyman Presses (TMag) and with RCBS (Rock Chucker) I had a Hornady LnL AP Press, and single stage, and I most recently had Lee Loadmasters, all of the presses load ammo and they all can do it very well, but I just wanted to try...

Thank you everyone for your input

Thanks guys for the input!

exactly

My Gempro 250 bit the dust, and I would like some suggestions on a good digital scale to replace it.

I added some light where the new press will go... If you can't tell I am chomping at the bit for the new press to get here ;)

Yes sir I did! Semper Fi!!!

The first thing the dealer covered in his demonstration of the press was the forward push and he emphasized that throughout our time together on the press. The only thing I missed was the spent primer solution, thanks for that link! All the other bases are covered. Thanks for your response...

Thanks guys

No, from Safeside LLC in Trevor.

Well, I bit the bullet today and pulled the trigger on the XL750 with the Case Feeder. I met with the closest Dillon dealer and he is a top shelf dealer, he went way out of his way to show me the differences in the Dillon and the Lee that I have been using. He spent two hours with me and let...

Well, as you can guess, I pulled the trigger and purchased the XL750 with the case feeder. I will add the other calibers that I need slowly and when it is all said and done I think I will be enjoying myself a lot more! I enjoyed my Lee Presses and have loaded thousands of rounds with them but...

The dealer has a good surplus of parts and other odds and ends so that is covered. I think I am going to Love it!

Excited might be an understatement. Yes I have been doing lots of research and I have tried several presses over the years, Lyman, RCBS, Hornady and Lee, all of them will reload ammo, but what I felt today using the Dillon Press was something else, I could feel the difference! Yes, it is a...

40 Minutes and well worth it!

As stated in an earlier post I am considering switching from the Lee Loadmaster to the Dillon XL750. My nearest Dillon dealership is Safeside LLC and I have an appointment today at 2:00pm to try out the Dillon, and load up some .45 Colt ammo to see if I really want to make the switch. I...