Search results for query: *

I ran into an issue yesterday while loading 223 on my LnL. The case feeder is doing a real nice job of dropping cases properly into the feed tube, but when the tube gets full it sometimes doesn't shut off the feeder and a real logjam ensues. It appears that the 223 case's small diameter allows...

I'm a new LnL AP owner suffering through the shortage of shellplates like so many others. I've managed to find a few, either from Midway or Sportsman's Warehouse. I bought the #1 at SW to use with 45 ACP knowing that there were some ejection problems with the EZ-Ject system. Well, it's...

Hi, I've just ordered a lock-n-load ap press and am preparing a followup order for accessories. Could someone who has purchased a press recently please clue me in on the following: 1. Which rotor does the powder measure come equipped with: pistol, rifle, or both? 2. If I want to load...

I am having difficulty uniforming the primer pockets on some .308 Lake City Cases. I believe that I have successfully removed the crimp, having run them through the RCBS pocket swager and also lightly chamfered the edge of the pocket. When I try to uniform the primer pocket, the tool is too...

Hello all, Wanted to wish everyone out there a very Merry Christmas. I hope that your stockings are stuffed with dies for your new favorite caliber and that you are all enjoying the day with family. May God Bless, RealBuffDriver

I recently worked up some .308 loads for my M1A using WC846 powder and pulled 147gr USGI bullets. I found a really good load that gives 2750 fps and st dev of 15 over a 5-shot string. Well, last week I ran across a Lee collet factory crimp die and decided to add it to my setup. Question...

Wow! I just checked my wish list at MidwayUSA and the prices have really gone up! :mad: Even with my dealer discount, I am now paying more than I think it would have cost without the discount a couple of weeks ago. This is not just on components. RealBuffDriver

I am preparing to trim 1000 lake city 308 brass.:eek: Up to now I've used a Lyman universal trimmer (hand cranked). The Lee setup is appealing because of the price and the potential for using it with my drill press. I am considering chucking the cutter in the drill press and the shell...

I picked up a hundred or so .45ACP brass with the headstamp *I*. Do any of you recognize this? Is it good brass to reload? Thanks! RealBuffDriver

I am considering purchasing an RCBS Precision Mic to determine precise headspace measurements for loaded rounds. It occurred to me that .308 Winchester and .243 Winchester have identical headspace. What is the difference, if any, between the precision mic gages? Is it only the plastic bullet...