The question of ball penetration from "hot loads" fired into Oak was brought up on another thread. The following results were obtained from a highly un-scientific experiment conducted in two parts.
Three balls were fired from an Uberti Walker for each test.
All chages were 777 ffg 55 grain...
Does anyone here know the formula for determining the ideal mouth diameter for a revolver forcing cone based on a given chamber diameter? Any help will be greatly appreciated.
This is just a little reminder about how not to shoot a bp or any other revolver.
http://www.auctionarms.com/help/forum/DisplayForum.cfm?SubjectID=22431
You may have to be logged in to see it.( not sure )
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.