Search results for query: *

guess this would be a question for fellow OCD dillon folks.... anybody washed their machine cover? it looks like a high quality tent material and i was a bit concerned the washing machine would compromise the fabric. yep.. i've checked the dillon site for washing instructions.. nada. As...

I'm replacing the pistol grip on my Mossy 500A with an ATI stock. The bolt that came out of the pistol grip is much too short (duh..)... would anyone be able to tell me the correct length of the "stock" stock bolt?

Just picked up some 160 gr. LC in lead and wanted to load them for .45 ACP- currently have Win 231 in the powder drop.... anyone loaded this with success? One of my favorite light plinking loads is 185 fp lead with 5.1 W231, but I have not been able to locate the 185 locally and thought this...

I have not actually seen the "Judge" by Taurus, but from the commercials it appears to be able to fire .410 & 45LC. How is this done? Am I also to assume that one "could" fire a .410 from a 45LC revolver- and vice versa? Before I get flamed for implying I would do this...no plans - yet.;)

Howdy folks, Any suggestions for loading 357's at about 38 velocities? I'll be using 357 brass, probably 158 grain cast bullets. I'm working up some light loads for a novice shooter- and I like not having to spend as much time cleaning the cylinder because of the shorter 38's! What kind of...

I have searched and might have missed it... so here goes. I am an experienced pistol and shotshell loader... but have only loaded once fired .308 (no problems with that one). 30/30 Win. New brass, full length sized (including the expander button) trimmed and primed. So far no problem....get...

Howdy folks, A buddy of mine was over just recently and we were firing his M1 Carbine and we noticed the rear sight was loose. Upon closer inspection I could not figure out how it was secured.... it appeared to have two small punch marks on the mounting surface... but no place for a screw...

Greetings, I have a TX carry permit and plan to travel to Missouri this summer.... it looks like to me on the Missouri web site that they honor TX permits, but I wanted to make sure I was reading it correctly. The rest of the regs look a lot like TX ... so no big mystery there... anyone out...

Just a bit curious about how many combination pistol and shotgun loaders there are out there. I have been loading several pistol calibers ranging from .32 ACP -.45 ACP and use a number of different powders... looked today and have a variety of 8 different powders in 1 lb. containers. All...

Having some difficulty finding much information on the .32 ACP for cast round nose 76 grain bullets. Lotsa stuff on the standard 60 & 71 grain, but I've got about 500 rounds of the 76's that I want to use! Here is what I have at this point- Win 231 @ 2.0 with .94 OAL- seems like a good start...

been looking for a used stainless 357 snubbie and found one today at a local proprietor for $300.00.... thinking pretty seriously about it but my gun trader book hits it about $250 - any opinions :confused: