Search results for query: *

I have a plastic stocked Marlin .17 HMR , which seems very accurate , but my groups seem to be handicapped by the crosshairs shaking, everytime my heart beats. Any suggestions how to eliminate this? I am using a tripod front rest with a leather bag on it and a rear leather sandbag.

I acquired this semi finished gunstock, . Would like to use it, but I can't figure out what action it fits. There are holes for three action screws. The two extreme screws are 7 15/16" apart. A magazine well cut out is 3 1/2 " long. I am hoping that someone can identify this action by looking at...

I am thinking of going to stainless pin media in my rotary tumbler. What liquid does everyone recommend? I am thinking the liquid doesn't matter much, probably try water with a little detergent.

I have a sporterized, Mauser large ring action in 8mm, free floated, bedded into Fajen wood stock. I want to unbolt the action from the stock for travel purposes. It's just so much cheaper to fly with a rifle case that comes in less than 60", length plus width plus depth. Do you think my...

I scrounged some .308 brass from the range, to add to my collection. I was about to reload some and noticed my old brass was headstamped FC .308 Win. The found brass is headstamped FC 14. Other than the crimped in primers on the FC 14, are there any differences I should know about? I am...

I want to make up some .38 Special, snake shot loads using Speer shot capsules. I have an abundance of Magnum small pistol primers that I would like to use up, to conserve my supply of standard small pistol primers. I will be using Titegroup powder. I know I don't need magnum primers, but...

I was at a flea market and came across a Weaver Scope in traditional Weaver box. It appeared to be a 3/4" or 7/8" tube .22 scope. However, the scope had no crosshairs in it, and no turrets on it. It's not like the turrets were ever there, no holes or other evidence of turrets. I seem to recall...

I have been trying to work up a light cowboy action load. I have settled on 2.5 grains of PB with 125 truncated cone lead bullets. Shooting them in Beretta Stampede revolvers. I find that the same load in the .38 cases seems to produce tighter groups than in the .357 case. Any ideas why and has...