Okay, I am short on time to properly develop a new load for my Winchester M70, post 64 but pre 70. I would like to get some load recommendations using H4350 with either a 165 or 168 grain bullet for a 1-10 twist rate so I can narrow down my ladder. I am thinking starting out at 57.5 gr of...
I have been getting a few messages inquiring about the details on some of the customizations I have made to my Hornady AP Lock-n-Load. So I thought I would just gather them in one place with the details instead of send out multiple messages. You got it, I am lazy but you probably already know...
Well last night I got a wild hair and bought a 357 SIG barrel for my HK so now I have to gear up for reloading for the 357 SIG. I have already searched the form and found out that I have to be careful which bullet to get so it looks like it will be the 124 grain Berry's HP as suggested by Fred...
Hey for anyone who is in the market for a good single stage press Graf & Sons is going to have the Lee Classic Cast Press on sale Wednesday May 30, for $38.99 that's half of their regular price. I just got the flier today in the mail and thought I would pass it on.
Hey everyone currently where is the cheapest wholesaler for 55 gr .224 PSP bullets in quantities of 1,000 or 2,000? I have checked Midway and Dillon, Midway is out of stock and Dillon is too high since they are not running a sale. I just 2,000 from Dillon last month for $126 delivered so I...
Hello everyone I have been following a recent thread where a fellow reloader had question as to whether he needed to pull a bullet because it was deformed slightly. Well the OP along with some of the others didn't have a bullet puller and I have an old RCBS Kinetic bullet puller but I am not...
Hello everyone, I just tried out my new Possum Hollow Kwick Case Trimmer this evening and all I can say is WOW! This $20 trimmer that trims off of the datum of the case's shoulder just like the Giraud or Gracey except you supply the motor. I chucked it into my drill press and I was off...
I found this timer for my tumbler at Lowe's today for $2.50. The price was $9.98 but when they scanned it at the register it came up with a $7.48 discount: what a deal!
The timer has four interval settings:2 Hrs., 4 Hrs., 6 Hrs., 8 Hrs. Because it has a photo cell you do have to put a...
Well I think I can honestly say I now have a custom one of a kind press now. Today I just installed the Dillon Roller Handle on my Hornady AP press. So I thought I would share with everyone the modifications I have made in case anyone is interested.
Here is a list of everything I have...
I have a question for anyone who owns both a Hornady AP and either a 550 or 650 with the roller handle. I want to know if the roller handle shaft of the Dillon is the same size and thread pitch as the Hornady. I have always liked the roller handle concept and I am going to order one for my...
Hey I about to run out of my last keg of Accurate 2200 for my .223 and I need to find a replacement powder. I am currently loading Nosler 55 gr Ballistic Tip with 23 gr of 2200 in my AR with a 1-9 twist any recommendations? I have noticed a lot of discussion about Varget but isn't it a stick...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.