Now that I've finally tuned the basic press to work reliably, I added the case feeder today. What a huge monstrousity hanging in the air. I sure do miss my $11 Lee case collator.
Once I torqued down the allen bolts on the clutch hub, case are dropping.
A third of them upside-down...
From Hornady 7/18/2007 to another member
I'm thinking they can use a Lee-type bullet feeder mechanism, but in reverse. Instead of placing bullets, the tuning-fork fingers grab the loaded round off the shellplate.
Alternatively, they can change to a full 72 deg rotation like other presses...
RCBS Low Primer Warning Interference LnL AP Powder Measure
I get about a 1mm interference between the low primer warning device and LnL powder measure whenever the carrier/primer tube travels up and down. The powder measure body is centered on the die so turning it doesn't create any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.