Search results for query: *

I put them in the 50 rd plastic boxes that factory shells come in then seal them on the wifes food saver. compact can keep charges seperated and water and dirt proof. works great.;)

all are saying that it will take a long time to get an awb through congress. Obama does not need congress he will just make another persidential dictate.:fire:

watch out for another Obama presidential order that bypasses congress and the constitution.

The scratch on the primer is not the problem with putting a live primer in a dummy round. The problem is that if it gets in with live rounds you may fire the thing and with just the primer in there and no powder it will get stuck in the barrel and when you scratch your head on what may have...

Varget is imported from Austrailia.

I have a bushmaster Varminter with a 1:9 twist and it shoots 55 grain v- maxes very, very well. 3 shots at 100 yds that can be covered with a dime. My undestanding is you can shoot 50-65 grn bullets with the 1:9 twist.

I read an article on the local news channel that about 50% of walmarts will sell firearms in the future, but no handguns.

craigman. just pull the unit to the edgeof your bench and open the drain with the original container under the spout and the container off the edge of the bench. easy as pie.

The 2nd amendment to our constitution has no excepts in it.

I have had a this happen mid way through a batch. I have found that the decapping pin gets loose. When this happens I just wiggle the pin and if it moves I remove and tighten the thing and then all is well until it gets loose again.

check to see that the hole in the die side is clear. It's ther to let air escape when lowering the ram.

the only problem that will cause is a discoloration of the clear plastic on the machine. I don't leave powder in my machine at all. It's sloppy reloading.

I had a concern about the number of overchages that i got with the 1500 combo. I called rcbs and they stated it was due to using powder that is a stick powder (verget). he stated to tilt the machine by putting a primer box under the front of it. This occurs because tricklers do not meter stick...

Fox Pro coyote call. I want to go yote hunting on Christmas day.:)

Could it be that the new Privacy thing you have to sign at the doctor. That they won't disclose your medical issues EXCEPT to the government should they request it. I would say it's just another list the government is useing to take away the freedom that the constitution gives us. 9-11 has been...

243, all references I have show a trim length of 1.750", maybe that's different for the x die.

Thanks

Should have read .012, these are once fired cases as the crimp had to be removed from the primer hole.

The cases where measured after resizing with a small base die.

I have some range pick up brass that is headstamped FC 223. The cases have a crimped primers and the red sealant on the old primers just like LC brass. My question is these cases are up to .120 shorter than the trim to length, are these ok to reload being this short.