Does anyone have good loads for bullets heavier than 80 grains? Like 88-90 grainers with H4350 or smiliar powders? Only can find loads with magnum powders which are hard get right now.
Thanks
Roc1
Simple to convert to Led your existing fixtures. Bypass ballast change lamps
I’m Master Electrician by trade but telling you it’s easy. Look on internet if unsure best way to go
I just bought 2lbs at powder valley to try out see if I like it myself. I know benchrest guys I shoot with like it. I hope it does well in 6 and 6.5 creedmoor. Harder find loads for it did download Norma guide.Norma brass is good will see
Roc1
Does anyone have good loads for Norma powder in 6mm and 6.5 Creedmoor? Using 105-108 gr bullets 6mm and 140-147 gr in 6.5.
Found some powder but never used any Norma it would be 203B and URP. Manual doesn’t list 6mm at all. Not sure about any of it. I know benchrest guys at club use it but I...
How many of you have loaded 40 caliber loads in 10mm brass? Any issues? I know you can do this just like loading 38 special loads in 357 cases but does it creat any problems? Wanted to load lighter target loads is reason.
Thanks
Roc1
Good information I have a 1873 32-20 that belonged to my great grandfather. I’m 4th generation to have it. I wrote Winchester years ago still have letter showing it left factory in 1891. I shot it when I was a kid with my grandpa. He told me many years ago his dad traded a shotgun for it. I have...
I agree I put SAO trigger in mine helps with reset S2 doesn’t have firing pin block do no worries there. I only changed springs didn’t feel it needed pro kit. I put pro kit in 97 and SP01 those made big difference. My S2 has short reset already in SA mode just wanted try SAO trigger. I like so...
I’m reloading 9mm for while now got components cheap but not cheap anymore. Impossible to find primers still have some but hope this lets up before I need more. It’s definitely worth reloading now like lot of you quit for quite awhile loading 9mm but back in it strong now. Got ton loaded up need...
The solution cleaned barrel 95% or better I’d say. It didn’t matter barrel wasn’t stainless I guess? I dried it and oiled it with a patch think it’s fine.
Thanks again
Roc1
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.