What are you replacing it with Scott? I have a 1201fp and it can be a little...invigorating with solids! Thinking about getting a decelerator or limbsaver etc... put on it
Old School; dropping off a backsteak to the old boy who cant get out hunting anymore
New School; dropping off a backsteak to the old boy who cant get out hunting anymore
Some things dont need to change i suppose...
Had a Franchi SAS12 with pistol grip and butt. Found it quite a bit easier on the shoulder to shoot, something to do with two points of recoil i suppose?
Quite awkward to shoot from the hip though!!
Just reasssembled the bolt on my beretta and wondering if there is meant to be a bit of play with the inertia spring inside the bolt?
When the action is locked back you can hear the spring move back and forward when you tilt the gun.
Ive only had it a few days so not sure if this is ok...
My little 1400? Anschutz loves CCI Minimags and my silenced 10/22 only ever gets Winchester Subs through it. Both real accurate rifles but the Anschutz is spooky with how good it is...and the Minimags knock the rabbits and magpies for 6...
Ive started fireforming cases for my 22 k hornet but am losing most to neck splits.
How mild a load is required for this? 8 grains of lilgun is too much, how much lower could i safely go?
Does anyone have loads with either lilgun or AR2205??
A good way i picked up was to tighten the screws up while holding the shorter 'leg' of the allen key. Once it gets sore to turn, its torqued up. Not exactly scientific but worked for me.
Its a good idea to use feeler guages too to make sure the gaps are even...
Cheers guys, i think all of you had a point in this one. I was looking forward to having some good lapua brass to reload but it may have been wishful thinking...a combination of hard brass and not enough lube in the neck is not a good start. I might just get some winchester 7/08 brass and start...
Im necking down some Lapua 308 brass for my 7/08, full length die, sizing wax and dry neck lube, it looks as if the necks are being pulled well out of square. Theres quite a bit of force required to get the case back out of the die so im wondering if the expander plug is the cause?
How else can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.