I have lots of 223 brass that I plan to reload. Are all brands basically the same or are there some that you prefer not to reload? I’ve read about staked or crimped primers. How do you identify them are what problems do they cause? Are there other things to watch out for?
I am interested in loading .223. I have been reloading .38 special and 9mm and am now thinking about .223. I have been looking at bullets which are about $0.11 a bullet. Is that a good price? What is a good powder to start with? I need small rifle primers, right?
Who has the best deals on...
I have an old model 12 that has a recoil pad that looks like this. It’s a 1927 16 gauge. I’m thinking about replacing it. Where is the best place to get one? I figure the old one is just held on with two screws.
I am looking for a mount that I could use to attach a Holosun HE507C-GR-X2 to the rail on my Kel-Tec CP33. Any ideas?
Here is a link to the Holosun.
https://www.primaryarms.com/holosun-he507c-x2-pistol-green-dot-sight-acss-vulcan-reticle
I am looking for a pistol rack for my safe. My shelf is 13 inches wide. I was looking at this one but it seems to be out of stock everywhere I look. I liked that it held 7 pistols.
https://hyskore.com/products/30058-7-gun-stackable/
What racks do you all have and like that are similar?
I am thinking about selling some 30-06 ammo that I have and am trying to determine a price. Any idea what it’s worth in today’s market? I have 8 boxes.
I am getting ready to load Berry’s 158 grain FP with HP-38. I got this data from the Hodgdon site. They only list a LSWC. Would that be considered the same thing or close enough?
I am getting ready to crimp 9mm for the first time. I started researching this step and saw somebody suggesting that you flair to 0.383, seat the bullet, and then crimp to 0.381. 0.381 lets the round drop into the chamber but barely sticks when pulling it out. I am thinking that I should go down...
I am loading 9mm for the first time and the 115 gr Berry’s bullets are seating crooked. My dies are RCBS. I posted a few times about it in another thread but thought I should start a new thread. Here is info from that thread explaining what is happening.
I tried seating a bullet and I think...
I am about to charge cases and seat bullets and want to do everything correctly. I have CCI 500 small pistol primers, Berry’s FP 125 gr plated bullets, and HP-38 powder. My Nosler reloading manual doesn’t show load data for this exact combination, so I am using the data off the Hodgdon site. I...
My powder measure came with two drop tubes, a large and a small. If I am loading 38 special, does it matter which one I use? The case fits into both of them. It fits a little better in to the large one. Which one do you guys use?
If only doing one method, which is preferred, wet or dry? I’m looking at a vibratory tumbler with corn cob media and rotary with SS pins. Which is the better way to go?
I’m thinking about getting into reloading and am in the research stage, so I have lots of questions. I’m trying to decide which press to start with. Is it better to get a kit or buy the parts separate? I’m sure separate would be more expensive. Which kits are good for someone starting out? I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.