Search results for query: *

Suppose if you had registered "Assault Weapons" with the State of CT. Suppose if you had those firearms insured and were to suffer a total loss, such as caused by fire or theft. I could find no provision in the terrible new CT laws allowing a person to replace these arms in such a...

As a CT resident, if one had legally manufactured their own personal firearm, before these new laws came into effect, that person wouldn't have been required to assign any serial number to that personal firearm. The new law doesn't specify that such personally manufactured firearm needs to...

Hello, Looked at a bolt action Mossberg 695 shotgun with synthetic stock. Found several in good shape for sale on gunbroker.com for $150 to $275 for comparable asking prices. Here is the problem: This shotgun has a spray painted on camouflage finish with several rust blemishes coming...

http://www.nraila.org/about-nra-ila.aspx Established in 1975, the Institute for Legislative Action (ILA) is the "lobbying" arm of the National Rifle Association of America. ILA is responsible for preserving the right of all law-abiding individuals in the legislative, political, and legal...

I have looked at a rifle that could be for sale, I just need to make an offer. A concentric circle 6.6mm bolt action long rifle. I lost my paper upon which I had recorded markings that would indicate the manufacturing arsenal, serial number and series number. There appeared to be a...

I am applying for a Federal Firearms License, just a C & R application for antique firearms. In box 7, applicant is: Individual. In box 9, position: Since I am applying as an individual, should I position myself blank as nothing? Is blank the best response? Is "Applicant, or Responsible...

My local newspaper ( in southeastern CT ) has an editor who tends to be one sided, and it's usually not on my side! http://theday.com/ Please show your support if you can. Thank You

All .45/70 rifles I have read about tend to have a slower twist rate barrel, commonly of 1:20". Am I correct to assume that a .45/70 barrel 1:20" twist rate could have a hard time stabilizing a subsonic 500 grain or heavier bullet? Would I want the projectile to be spinning at a higher rpm...

Does anyone know if or when the coveted AAC Honeybadger rifle will be available for sale to the general public?

Liking the accuracy of my HK pistol, but looking at newer Walthers as seeming comparably equipped for less money. How much better accuracy is common from the more expensive pistol? How do the barrels compare?

http://www.sturmgewehr.com/webBBS/nfa4sale.cgi?read=148549 I saw this for sale and was wondering if Bushmaster would still offer factory repair services for such an MG likely produced in the 1970s. Is there any other specialist armorers familiar with this type of item? From what I gather, the...

I was looking at two barrels for an AR15 type rifle, chambered in .300 blackout cartridge. Both come with a low profile gasblock. The CMMG brand barrel comes in at $250.00 and would work. The Noveske brand stainless steel barrel comes in at $350.00 and has more attention to detail in...

.