Search results for query: *

Hi all, I'm getting ready to finally shoot the Hawken and have a question. While looking at the load data for 50 cal. PRB, there are 2 Muzzle velocities listed for each load. For example: 70 grs. FFG lists 1643 fps and 1050 fps. Is one for cap lock and the other flint? Seems like an awful lot...

Just how many dead horses can we beat? Bob (who just suggests we all go and shoot...)

Hi guys, I would like to know if Alliant RL15 is a suitable powder for said rifle (150 gr. bullet). Also, any other powder reccomendations would be welcome. Thanks, Bob

Hi all, I'm looking to replace my bench that was lost in a flood. I can't seem to find anything under $300. I have searched the net seemingly endlessly and have only found 1; made by Kencraft. I have looked at a couple of workbenches at the local hdwe. stores, they ain't gonna cut it...

Hi all, Is there a standard? 1 1/2" belts, 2" belt slots in holsters, etc. Does anyone know what the deal is? I recently got a Texas Gunleather belt which is 1 3/8", and my Dillon slide holster is approx. 1 7/8". I am used to IWB, but am leaning towards belt slides for CC. Basically, ARRGH...

Hi all, I found this revolver today. It looks nearly new, has the "flat" blue box, original manual, and paper wrap. They want $275 for it and I was tempted (been looking around off & on for a few years after shooting a friend's). Literally no end shake/play and a very small amount of...

Hi guys & gals, I'm curious if anyone has had any experience with this ammo (apparently US manufacture WWII vintage, boxed in sealed tins, re-imported from Russia). Also, I'd like to know where you got it and how much it cost. Many thanks, Bob

I need to remove the action from the stock. I've done this once before and can't remember the tightening sequence for the fore and aft action screws (need to check the trigger; it's gone "2-stage" in a way). I'll reiterate; do I snug the rear & fairly honk down on the front or vice-versa? Should...