Boy such great information
The CORRECT TERM in MN is Permit to Carry
And neither a PERMIT TO PURCHASE nor a PERMIT TO CARRY in MN exempt a permit holder from NICS CHECK when buying from a FFL HOLDER in MN.....
But of course this is the internet SO IT HAS TO BE TRUE... NOT
personally if you spent that kind of ching on a rifle, then spending good $ on brass is what you need to do. Lapua, Redding Type S Neck Sizer with 336 bushing, and a body die to bump the shoulder occasionally.
You got crappy military brass fired from a MG. You need a small base die for the...
MN Law trumps NFPA
SECTION 3306
SMALL ARMS AMMUNITION
3306.1 General. Indoor storage and display of black powder,
smokeless propellants and small arms ammunition shall comply
with this section and NFPA 495.
3306.2 Prohibited storage. Small arms ammunition shall not
be stored together with...
Best advice
Treat plated bullets like lead. Berrys are not thickest of the plated bullets.
Montana gold Bullets in case qty is best bet, Precision Delta, and Zero Bullets from Roze Dist are very good options jacketed bullets.
http://czcustom.com/Zero-Bullets.aspx is a great source for...
The two best additives are simple
Iosso Case Polish and Flitz Metal Polish.
For Bling Bling Bright nothing beats fresh corn cob media with either of the abovie.
14/20 Grit can be bought at Graingers or order from McMaster Carr.
The Lee Carbide Factory Crimp die is an answer to no problem I know of.
For cast lead bullets it acts a sizer die, and thus can contribute to leading problems. It will create more problems then it will ever supposedly solve?
I have been loading since I was 13 so that makes for 38 years. I...
First you can not duplicate the load.
They use non canister grades of powder, and ATK suggests RL15 variant.
What you can do....
#1 Chrono some FGM in your flavor.
#2 Work up a load to match that with the Sierra 168 or Nosler 168 OTM bullets. Use RL15 and Fed 210M primers. Federal...
That is way too much Varget for Fed Brass. Not if you are using Lapua or Win. But, you should recheck you data source for the components used.
Change primer to BR2 or 210M.
Here is visual ratio fill bowl of polisher up half way with brass. Then add media till about 7/8 full run tumber for a few min to let media settle then make sure the brass is covered to keep dust down. Just tear used dryer sheet into 4 strip. If it take more then 2 hours to polish brass with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.