Search results for query: *

The major affect I have found with my colt for shooting HP is that the tube is not floated and the rear sight adjustment is 1moa for elevation. I want to replace both. The 2 pins on the front sight are very stubborn. I mic'ed to make sure I wasnt driving the wrong direction but they dont seem...

Can anyone point me to a sight with good pictures of how a sling is properly "slung" for typical "accros the course" match shooting? I can find some that partially show maybe the forend and about the left hand but I cant find a good pictures of a sling that shows the "Loop" or maybe a pictures...

I want to install a Jard 3# trigger assembly in my Colt AR15 Match .223. I understand that it is neccessay to clearance the sear block. What is the initial function of the sear block that does appear in most Colts? What is the risk? I read it can be done with a dremmel. Can you tell me if Im...

I am looking for a set of adjustable Tritium sights for my Ruger Alaskan .454 Casull. Will the ML20996 Meprolite sights fit?

Can you tell who I might send my Ruger Alaskan to for the changing out of the front and rear sights. I want to remove the stock set-in front with Meprolights Tritium front and adjustable tritium rear. It appears that a Dovetail will need to be milled to handle the front. Really need someone...

Why would the barrel appear to be overtightened or rotated past center? I am guessing a degree, enough the be visible. How would it be squared up?What should the gap bwtween the cylinder and barrel be? It may be about 1mm gap currently. Its a 71/2" barrel.

Need to drop the action. Can you tell me where to find the disassembly steps. Fails to cycle, bolt jams back. I'd like to begin with a good cleaning and check for burrs.

Has anyone hands on with the SPR22? Double rifle manufactured in Baikal Russia. They should have been out about a year now. Ive got a "want only" going on and wonder if anyone has shot it, 30-06 or the 45-70. Has it been drilled and tapped for scoping? I know you get what you pay for but I...

could someone tell me how to remove the bolt?

I have just installed a set of Leopold 26mm rings and a one piece adjustable base. The front ring is dove tailed, the rear is "clamped". Lets assume that the front rings locked in "square to the bore" when rotated into the dove tail and by chance the adjustment screws on the base were set...

I have a somewhat different situation. On my Redfields and Leopolds the tubes are .095" diameter. I have aquired an old Kollmorgen 2 3/4X that has a tube diameter of 1.0225. It was mounted on a 10/22 and I noticed that there was a large gap beween the tube and rings I laid it in various 1"...

Could someone point me to a detailed step thru procedure for disassembly and reassembly for a model 70 win bolt. Thanks Tom