Hope ya'll don't think I'm nit-picking with this question, but I want to know how to determine the correct size when selecting a bushing for a neck re-sizing or full length re-sizing die.
The instructions that came with the dies say to measure the outside neck dimension of several factory...
I don’t quite understand the concept of “bumping headspace.” When should one employ that technique rather than fully re-sizing the case.
If I start with once-fired factory brass (fired from my rifle) I know I can simply re-size the neck using my neck sizing die with bushing in place. After...
Apologies in advance for this newbie question.
I'm about to start reloading (rifle) and I've been reading as much as I can before venturing forward. I've also been watching experienced reloaders and asking lots of questions - but here's one I haven't asked before: When measuring group size...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.